Stored water in a loft

Would you brush your teeth in this ? No, not knowingly but one of my new customers had been. A cold water storage vessel (c.w.s.v.) should be fitted correctly and to current regulations. A lid is a must, not a piece of wood or some polystyrene but a fitted lid which is made for that.. read more →

Flues in voids

A lot of the things we see by other so called “plumbers” are often quite amusing, but sometimes they can be dangerous. On this occasion we found an incorrectly fitted flue. As you can see there are no support brackets and the flue has become detached. Also the flue route wasn’t fitted to manufacturers instructions. We classed this.. read more →

Power Flush

We were called to a house where a new boiler was fitted two years before and the owner was having problems with their hot water. Every time they had a shower the water kept going hot and cold. It was the same from every tap. Also when the boiler had fired on full flame there.. read more →

Mind the Gap

We see this far too often. Lazy fitters not even making good the flue after installation. This one didn’t even need ladders to sort it. Installation was at ground level. read more →

Cowboy Plumbing

Rather than change the gas pipe to the hob, why not cut off the hob fitting to suit your pipe ? When you buy a hob, it generally comes with a formed fitting which the plumber can connect onto with standard fittings. This pipe had been cut back and a compression fitting had been over-tightened.. read more →

Dodgy Pipe

We were called to a gas leak. The customer had already correctly isolated the gas before we arrived. After isolating all the appliances from the gas supply, there was still a big drop in pressure. By using leak detection fluid we found an un-soldered fitting. This was corrected and once gas was re-tested we reinstated.. read more →